Straight Benelli recoil pad adapter kit

Description

Optimize your stock length exactly to your preference and customize it with different recoil pads.

Recoil pad adapter kit that snaps on to Benelli ComforTech stock. The kit allows the use of screw attachment aftermarket recoil pads and spacers.

Straight version, this does not change the original pitch angle of the stock. Full kit includes spacers and used with SHU 17mm recoil pad, gives you the adjustment from 17-35mm. You can add more spacers to increase the length of pull even more. The adapter works also without any spacers, and it can be ordered separately.

Full kit includes:
– Benelli adapter base
– 10mm spacer
– 5mm spacer
– 3mm spacer
– spacer centering pin
– screw set

Adapter base only includes:
– Benelli adapter base
– screw set

10mm spacer only includes:
– 10mm spacer
– spacer centering pin
– longer screw set

Includes the adapter set only, recoil pad ordered separately.

Pre-drilled for 82mm distance between mounting screw center points.

Assembly: center spacers to the base clip with included pin (not necessary), screw the recoil pad on with long enough screws, snap on the assembly to the stock
Disassembly: remove the recoil pad and screws, remove the spacers, push in the adapter base so that the hooks are dislocated and take it out from the stock

Adapter base is rigid, and will not work the same way than soft elastic Benelli orginal recoil pads. Adapter base must be dislocated before disassembly!

Weight: total 60g with screws (adapter base 10g, 10mm spacer 24g, 5mm spacer 12g, 3mm spacer 7g)
Material: nylon

Note: Updated to gen2 10/2021, new appearance to give better looks with all Comfortech versions

Note: Benelli Nova non-ComforTech stock dimensions are slightly different than Benelli ComforTech.  This kit will work but will require some fitting. Material can be removed from the adapter base so it can be assembled to Nova stock. Also the outside width of the Nova and ComforTech stocks are slightly different.