Tapered Benelli recoil pad adapter kit

Description

Optimize your stock length exactly to your preference and customize it with different recoil pads.

Recoil pad adapter kit that snaps on to Benelli ComforTech stock. The kit allows the use of screw attachment aftermarket recoil pads and spacers.

Tapered version, that changes the original pitch angle of the stock. Used with SHU 17mm recoil pad, used with spacers this kit gives you the adjustment from 24-35mm on average, measured from the center of the recoil pad to the end of the stock. The adapter base can be used also without spacers. Kit includes 2pcs pitch spacers that are both tapered 10mm, each creating approx 4.5° additional pitch. If you require additional length of pull, add a extra SHU spacer (+4mm each) with the recoil pad assembly.

When shooting targets in low angles and horizontally, traditional recoil pads are typically not fully supported by the shooters body at the top of the stock. Increasing pitch will bring the support point of the stock higher. When the the support point is higher and closer to the barrel line, muzzle rise will be reduced.

Includes:
– Benelli adapter base
– pitch spacer #1
– pitch spacer #2
– spacer centering pin
– screw set

Includes adapter set only, recoil pad ordered separately.

Assemble required spacers in this order: #1, #2. Because the spacers are tapered, the holes for the screws are angled also. So the screws won’t fit well if the assembly is not done in this order. Pitch spacer #1 is the one with the Innovatac logo on top.  Align spacers to the adapter base with included pin.

Pre-drilled for 82mm distance between mounting screw center points.

Assembly: center spacers to the adapter base with included pin, screw the recoil pad on with long enough screws, snap on the assembly to the stock
Disassembly: remove the recoil pad and screws, remove the spacers, push in the adapter base so that the hooks are dislocated and take it out from the stock

Adapter base is rigid, and will not work the same way than soft elastic Benelli orginal recoil pads. Adapter base must be dislocated before disassembly!

Weight: total 60g with screws (base clip 10g, pitch spacer #1  15g, 5mm spacer 12g, pitch spacer #2  15g)
Material: nylon

Note: Updated to gen2 10/2021, new appearance to give better looks with all Comfortech versions. 

Note: Benelli Nova or non-ComforTech stock dimensions are slightly different than Benelli ComforTech.  This kit will work but will require some fitting. Material can be removed from the adapter base so it can be assembled to Nova stock. Also the outside width of the Nova and ComforTech stocks are slightly different.