Optimize your stock length exactly to your preference and customize it with different recoil pads.
Recoil pad adapter kit that snaps on to Benelli ComforTech Compact stock. The kit allows the use of screw attachment aftermarket recoil pads and spacers.
Tapered version, that changes the original pitch angle of the stock. Used with SHU 17mm recoil pad, this kit gives you the adjustment from 22-42mm on average, measured from the center of the recoil pad to the end of the stock. Kit includes 10mm, 5mm and a additional pitch spacer that tapered for additional 10mm, making the additional pitch adjustable from 4.5° to 9° without removing material from the spacers.
When shooting targets in low angles and horizontally, traditional recoil pads are typically not fully supported by the shooters body at the top of the stock. Increasing pitch will bring the support point of the stock higher. When the the support point is higher and closer to the barrel line, muzzle rise will be reduced.
Benelli Comfortech Compact stock is approximately 20mm shorter than normal Comfortech stock. Kit includes a measuring jig, that will help you to cut down a normal stock accurately. After cutting, the stock will accept Innovatac Benelli Compact adaper kit. The full kit includes enough spacers to bring the compact stock back to similar length than the orginal Comfortech stock, if Compact length is too short for the user.
When the stock is cut, older ComforTech stocks will also accept Benelli original Compact recoil pad, which is smaller than the normal recoil pad. Normal Benelli recoil pad will no longer fit. New ComforTech 3 stock (SBE3, Speed, etc) can be cut and it works well with this InnovaTAC compact adapter, but does not accept Benelli original Compact recoil pad very well when they are shortened.
– Compact cutting jig
– Benelli Compact tapered adapter base
– 10mm spacer (version available without this spacer)
– 5mm spacer
– pitch spacer #2
– spacer centering pin
– screw set
Includes adapter set only, recoil pad ordered separately.
Assemble required spacers in this order (10mm, 5mm, pitch spacer #2). Because the spacers are tapered, the holes for the screws are angled also. So the screws won’t fit well if the assembly is not done in this order. 10mm, 5mm spacer and/or pitch spacer #2 can be left out if not needed. 10mm or 5mm spacer are not required in the middle.
Pre-drilled for 82mm distance between mounting screw center points.
Assembly: center spacers to the adapter base with included pin, screw the recoil pad on with long enough screws, snap on the assembly to the stock
Disassembly: remove the recoil pad and screws, remove the spacers, push in the adapter base so that the hooks are dislocated and take it out from the stock
Delivery time for backorders approx 4 weeks (if not in stock)