Optimize your stock length exactly to your preference and customize it with different recoil pads.
Recoil pad adapter kit that screws on to Beretta 1301 stock. The kit allows the use of screw attachment aftermarket recoil pads and spacers. Not for Beretta orginal recoil pad.
Tapered version, that changes the original pitch angle of the stock. Used with SHU 17mm recoil pad, this kit gives you the adjustment from 24-30mm on average, measured from the center of the recoil pad to the end of the stock. Kit includes 2pcs pitch spacers that are both tapered 10mm, each creating approx 4.5° additional pitch.
When shooting targets in low angles and horizontally, traditional recoil pads are typically not fully supported by the shooters body at the top of the stock. Increasing pitch will bring the support point of the stock higher. When the the support point is higher and closer to the barrel line, muzzle rise will be reduced.
– adapter base
– pitch spacer #2
– spacer centering pin
– screw set
Includes adapter set only, recoil pad ordered separately.
Pre-drilled for 82mm distance between mounting screw center points.
Assembly: screw on the recoil pad adapter base on with Beretta orginal screws, center spacer #2 with included pin, screw on the recoil pad with the right screws
Disassembly: remove the recoil pad and screws, remove the recoil pad adapter base and screws
Note: do not overtighten when mounting the M4 recoil pad screws, hand tighten to maximum 2Nm or less
Weight: total 40g with screws (adapter base 17g, pitch spacer #2 17g)