Benelli recoil pad adapter base


Recoil pad adapter base for Benelli ComforTech

In stock (can be backordered)


Optimize your stock length exactly to your preference and customize it with different recoil pads.

Recoil pad adapter base that snaps on to Benelli ComforTech stock. This is the part where the screws are attached. Recoil pad can be mounted flush to the stock with this adapter base. Use Innovatac spacers, adapter kit or SHU spacers to increase the length of your stock if necessary.

Straight version, this does not change the original pitch angle of the stock.

– Benelli adapter base
– screw set

Includes adapter base only, recoil pad ordered separately.

Pre-drilled for 82mm distance between mounting screw center points.

Assembly: screw the recoil pad on with long enough screws, snap on the assembly to the stock
Disassembly: remove the recoil pad and screws, (remove the spacers,) push in the adapter base so that the hooks are dislocated and take it out from the stock

Adapter base is rigid, and will not work the same way than soft elastic Benelli orginal recoil pads. Adapter base must be dislocated before disassembly!

Weight: total 15g with screws
Material: nylon

Note: Benelli Nova or non-ComforTech stock dimensions are slightly different than Benelli ComforTech.  This kit will work but will require some fitting. Material can be removed from the adapter base so it can be assembled to Nova stock. Also the outside width of the Nova and ComforTech stocks are slightly different.

Additional information

Weight 0.015 kg
Dimensions 13 × 5 × 1 cm


There are no reviews yet.

Be the first to review “Benelli recoil pad adapter base”

Your email address will not be published. Required fields are marked *