Description
Optimize your stock length exactly to your preference and customize it with different recoil pads.
Recoil pad adapter kit that snaps on to Benelli ComforTech Compact stock. The kit allows the use of screw attachment aftermarket recoil pads and spacers.
Straight version, this does not change the original pitch angle of the stock. Full kit includes the adapter base and 10mm spacer. More Innovatac and SHU spacers can be added to increase length of pull.
Benelli Comfortech Compact stock is approximately 20mm shorter than normal Comfortech stock. With the adapter base attached you can cut down a normal stock accurately. After cutting, the stock will accept Innovatac Benelli Compact adapter kit. By adding spacers the compact stock can be adjusted longer if needed. The cut stock stock will also accept Benelli original Compact recoil pad, which is smaller than the normal recoil pad.
Full kit includes:
– Benelli Compact adapter base (used also as the cutting jig)
– 10mm spacer
– spacer centering pin
– screw set
Adapter kit only includes:
– Benelli Compact adapter base (used also as the cutting jig)
– screw set
10mm spacer only includes:
– 10mm spacer
– spacer centering pin
– longer screw set
Includes adapter set only, recoil pad ordered separately.
Pre-drilled for 82mm distance between mounting screw center points.
Assembly: center spacers to the base clip with included pin, screw the recoil pad on with long enough screws, snap on the assembly to the stock
Disassembly: remove the recoil pad and screws, remove the spacers, pry out the adapter base so that the hooks are dislocated and take it out from the stock
Weight: NA
Material: nylon
Delivery time for backorders approx 4 weeks (if not in stock)
This is not the tapered compact kit shown in the below video. This kit is straight. Cutting procedure is the same.
