Tapered Benelli recoil pad adapter kit

79,00 

Tapered recoil pad adapter kit for Benelli ComforTech

In stock

Description

Optimize your stock length exactly to your preference and customize it with different recoil pads.

Recoil pad adapter kit that snaps on to Benelli ComforTech stock. The kit allows the use of screw attachment aftermarket recoil pads and spacers.

Tapered version, that changes the original pitch angle of the stock. Used with SHU 17mm recoil pad, this kit gives you the adjustment from 24-35mm on average, measured from the center of the recoil pad to the end of the stock. Kit includes 2pcs pitch spacers that are both tapered 10mm, each creating approx 4.5° additional pitch.

When shooting targets in low angles and horizontally, traditional recoil pads are typically not fully supported by the shooters body at the top of the stock. Increasing pitch will bring the support point of the stock higher. When the the support point is higher and closer to the barrel line, muzzle rise will be reduced.

Includes:
– Benelli adapter base
– pitch spacer #1
– 5mm spacer
– pitch spacer #2
– spacer centering pin
– screw set

Includes adapter set only, recoil pad ordered separately.

Assemble required spacers in this order (#1, 5mm #2). Because the spacers are tapered, the holes for the screws are angled also. So the screws won’t fit well if the assembly is not done in this order. Pitch spacer #1 is the one with the Innovatac logo on top. 5mm spacer and/or pitch spacer #2 can be left out if not needed. 5mm spacer is not required in the middle.

Pre-drilled for 82mm distance between mounting screw center points.

Assembly: center spacers to the base clip with included pin, screw the recoil pad on with long enough screws, snap on the assembly to the stock
Disassembly: remove the recoil pad and screws, remove the spacers, push in the adapter base so that the hooks are dislocated and take it out from the stock

Weight: total 60g with screws (base clip 10g, pitch spacer #1  15g, 5mm spacer 12g, pitch spacer #2  15g)
Material: nylon

Note: Benelli Nova or non-ComforTech stock dimensions are slightly different than Benelli ComforTech.  This kit will work but will require some fitting. Material can be removed from the adapter base so it can be assembled to Nova stock. Also the outside width of the Nova and ComforTech stocks are slightly different.

 

Additional information

Weight 0.07 kg
Dimensions 30 × 10 × 2 cm

Reviews

There are no reviews yet.

Be the first to review “Tapered Benelli recoil pad adapter kit”

Your email address will not be published. Required fields are marked *